Grand Tracker Bar-End Mirror

Siirry Puig-merkkikauppaan

Moottoripyörien tuulilaseja ja Styling Parts -osia

Puig perustettiin 50 vuotta sitten Barcelonan kupeessa. Nykyään 8 000 neliömetrin tuotantotiloissa valmistetaan laadukkaita auto- ja moottoripyöräalan tuotteita uusinta kehitys- ja tuotantotekniikkaa hyödyntäen. Maailman parhaat kilpa-ajajat luottavat Puig-tuulilaseihin. MotoGP-kilpaurheilusta ammennettu kokemus ja tuotekehitys näkyvät suoraan sarjatuotannossa. Tuotevalikoima käsittää laadukkaasti työstetyt takapyörän suojukset, alaspoilerit ja kaatumaraudat. Kaikki tuotteet toimitetaan tietysti yleisellä käyttöluvalla (ABE) ja asennusohjeella.

This product is made of high-quality CNC-machined aluminium and will look great on your motorbike.

To ensure that it gives you many years of service, please observe the following care instructions:

1. After installing the product, and each time you wash your motorbike, apply a wax-based care product, e.g. Procycle Polishing Wax, Order no. 10004923 for protection against wind and weather. You may need to repeat the application after an outing in winter weather, rain or salty air (near the coast).

2. Remove any corrosion as soon as possible using a standard aluminium polish (e.g. Autosol Aluminium Polish, Order no. 10004421).

Modern vehicle accessories of different types now frequently carry an "E" approval mark valid throughout Europe. This "E" mark, which is made up of a combination of letters and numbers, is clearly displayed on the product and shows the application tested, the country in which testing was carried out and, where appropriate, the vehicle type to which approval applies. EC type approval for exhaust systems, for example, are always issued for a specific vehicle type, whereas in the case of lighting, they apply to an entire group of vehicles, e.g. motorcycles.
This certification mark is the sole proof of legality stipulated by law, i.e. no written report or entry in the vehicle documents by TÜV (German Technical Inspection Association) is required. However, when it comes to installing accessories, the relevant guidelines of the Road Traffic Licensing Regulations (StvZO) must always be observed.
At at a roadside check or a TÜV vehicle inspection, the registered keeper is only required to show the "E" mark. It is then up to the official in charge whether to check the mark with the Federal Motor Transport Authority (KBA) in Flensburg (or equivalent type approval authority in other countries), which is able to decode all certification marks.

Original parts on newer vehicles that have been given an "E" mark at the factory may only be replaced with accessories that have likewise undergone E-approval. An E-certified mirror may not, for example, by replaced with a mirror that only has TÜV approval under the German vehicle licensing regulations.

Dimension sketch mirror