Drag Bar -ohjaustanko, alumiinia

Siirry Rizoma-merkkikauppaan

Koe Rizoman huippuun hiottu laatu

Uppoudu Rizoman maailmaan, jossa muotoilu ja toiminnallisuus kohtaavat. Eksklusiivisissa tuotteissa yhdistyvät italialainen muotoilu ja huipputeknologia, ja ne asettavat uusia standardeja tyylin ja suorituskyvyn suhteen. Jokainen kappale on mestariteos, joka on valmistettu äärimmäisen tarkasti ja yksityiskohtaisesti. Rizoma nostaa sinut ja moottoripyöräsi uudelle tasolle – se edustaa laatua, innovaatiota ja vertaansa vailla olevaa estetiikkaa. Tutustu nyt valikoimaan ja nosta ajokokemuksesi seuraavalle tasolle. Koe ainutlaatuinen laatu, jota vain Rizoma voi tarjota, ja nauti erehtymättömästä muotoilusta, joka erottaa sinut muista.

Rizoma – Enhancing beauty

Made in Italy

This product is made of high-quality aluminium and will look great on your motorbike. To ensure that it gives you years of pleasure, please observe the following instructions: To keep this product in top condition, it should be treated after long trips in winter, or in rain or salty air (near the coast), and also at periodic intervals.

Water and salt encourage corrosion. After cleaning (e.g. with Procycle Special Gel Cleaner, Order no. 10004909), we recommend regularly polishing aluminium parts with standard aluminium polish (e.g. Alu-Magic, Order no. 10004031).

Technical accessories whose operational safety depends not only on their own strength and function, but also on proper installation on the vehicle, are often supplied with a TÜV (German Technical Inspection Association) certificate. The user is obliged to have such accessories immediately registered in the vehicle papers by a TÜV test centre. This also involves the TÜV inspector checking the vehicle's operational safety. A charge is made for such registration.
Today, TÜV reports are increasingly issued for specific types of vehicle. However, no manufacturer is able (e.g. for cost reasons) to have their products tested on all vehicles which might use them. If a vehicle model is not listed, it is the inspector who has to decide about registration on the basis of his technical expertise; the strength of the product and its roadworthiness are confirmed by the existing TÜV report.
Since 2002, TÜV only accepts component certificates which include verification of the manufacturer's quality management system according to the requirements of §19 Appendix XIX of the German Road Traffic Licensing Regulations (StVZO) in the form of a valid certification document. Older reports can now only be used in exceptional circumstances in the course of a full technical inspection (Bauratabnahme), but the inspector is by no means obliged to make the entry in the papers.